FS: Custom Billet Stainless Steel Shift Knobs
 

Hello all,

Up for sale: are two shift knobs that I made through various different processes. They started out as a solid rod of SS and were turned down on a lathe, then chamfered top and bottom and then drilled for threads. After turning on the lathe, I spent hours polishing them on many different wheels with four stages of polishing compound (final polish was with "jeweler" grade).

Model Name: Stainless Slug

The Design: Roughly 80mm long and 23mm wide (3 inches x 7/8th inch).
The threads are 10mm x 1.5mm and are all the way in the top of the knob so that this knob will sit as low as possible.

I know for sure this will fit on integras. I have heard that 10 x 1.5 is the standard threading for all hondas, dont know if it is fact so make sure you know this will fit your car if it is not an integra!

Attachment 1092

Here they are:

Attachment 1093

Here is how they will look installed: (Stunning!)

Attachment 1094

These are extremely high quality, custom, shiny billet SS and unmatched by any thing you will find on eBay.

I am asking $75.00 Shipped. Payment VIA paypal IM Me!

Thanks for looking,

Mike Bell