I have installed the lid spoilers and full spoilers before, but the one I just got in for the wife's Accord and a discrepancy in the template. See the attached photo. I don't know if the marking hole is right and the print is off, or the other way around. I certainly don't want to drill the hole wrong! Notice the "Marking" cross-hairs, and where the hole is actually punched.

 

Measure between the studs on the spoiler and the holes on the template and see if they match ,if not adjust,either way the holes will be covered.

 

They sent me a PDF template, and I can see the hole is correct, but the print was just offset, so I'm good!

 

Good news,post up a picture when mounted.

 

Here it is installed.

 

Outstanding job,looks great.