I have a stock P75 ecu that I've socketed and chipped myself. Before the socket the ECU ran my JDM b20b perfect and had no issues. Now anytime I load a basemap into the ecu it kicks the car into limp mode. I was wondering if I did anything wrong?

Heres everything I did:

- soldered in 28 pin socket

- soldered C51 & C52 Capacitors

- soldered 74hc373 chip

- jumped j1

- soldered datalogging port into CN2

- replaced C14 capacitor

- Cut j12 for datalogging

Am I missing something? All the solder points are clean and are not touching any other points. I'm using crome and a stock P75 basemap. I also am removing the checksum routine before burning the chip. I've attached some pictures.

28 Pin added

C51, C52, CN2 port & J1 jumper added.

C14 Capacitor replaced

J12 Cut for datalogging