Gen 4 3D Printed Cup Holder Foam Insert
Thread Starter
|
Junior Member
Joined: Nov 2024
Posts: 2
Gen 4 3D Printed Cup Holder Foam Insert
Hello everyone. I have a 3D printer an my wife asked me to try and make a new insert for her 2012 Odyssey since the foam was deteriorating. I made one and it worked out pretty good.
I made a YouTube video with installation instructions (the video has a link to my eBay page where you can buy one). The flexible plastic is much more durable than the foam from the factory. Also, since it's 3D printed, I can make it in any color that I can source the filament in.
If you want a custom color, please message me.
Even if you go with another option for the foam, I hope the installation video helps.
I made a YouTube video with installation instructions (the video has a link to my eBay page where you can buy one). The flexible plastic is much more durable than the foam from the factory. Also, since it's 3D printed, I can make it in any color that I can source the filament in.
If you want a custom color, please message me.
Even if you go with another option for the foam, I hope the installation video helps.
Thread
Thread Starter
Forum
Replies
Last Post
