This is on a 2005 Honda Accord. The fuses don't look blown. My understanding is that this is usually a result of a bad resistor or transistor for the blower motor. I don't know how to get at that stuff though and was wondering if someone has a diagram showing how to get to the wiring I need to examine.

 

im not sure exactly where everything is but this website should definately be able to help http://diagramwiring.net .. if not just go to the dealership they can print you off a diagram (the will try and heckle you into bringing the car in but it will cost a lot) but the service department can print you out a diagram if need be.. and its free

 

Welcome to the forum,I would pull the fuse and look at it close,I have seen fuses blow and at first glance look OK,worth a try.Then check out the site 91Hayden gave you.

 

I actually swapped out the relevant fuses (at least I think they were the right ones) with known good fuses to no effect. I will check 91Hayden's link.

 

It's not a wiring diagram that I need so much, as I need to know which parts of the dash to remove, where the screws are, stuff like that.

 

Oh well in that case i would either go to your local auto parts store and grab a repair manual (those things come in handy more than you think lol) or just swing by the dealerships service department and ask them to print you up a diagram (this is something i do when the repair manual isn't detailed enough)